| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Density/Specific Gravity |
*** g/cm³
| ASTM D792 | |
Melt Mass Flow Rate(MFR) | | | |
300℃/1.2 kg |
*** g/10min | ASTM D1238 | |
Molding Shrinkage | | | |
Flow |
***~*** % | ASTM D955 | Flow, 3.2mm |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | | | |
Yield |
*** kg/cm² | ASTM D638 | 3.2mm，50mm/min |
Tensile Elongation | | | |
Break |
*** % | ASTM D638 | 3.2mm，50mm/min |
Flexural Modulus |
*** kg/cm²
| ASTM D790 | 3.2mm，10mm/min |
Flexural Strength | | | |
- |
*** kg/cm² | ASTM D790 | 3.2mm，10mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | | | |
23℃ (73℉) |
*** kg·cm/cm | ASTM D256 | 3.2mm |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell R |
*** R
| ASTM D785 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | | | |
1.8 Mpa (264 psi)（18.6kg/cm²） |
*** °C | ASTM D648 | 6.4mm ，Unannealed |
Vicat Softening Temperature(VST) |
*** °C
| ASTM D1525 | 5kg, 50℃/h |
Relative Temperature Index(RTI), Imp | | | |
- |
*** °C | UL 746B | |
Relative Temperature Index(RTI), Elec | | | |
- |
*** °C | UL 746B | |
Relative Temperature Index(RTI), Str | | | |
- |
*** °C | UL 746B | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | | | |
HB |
*** mm | UL94 | |
HB |
*** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity |
*** Ohm-m
| ASTM D257 | 23℃ |
Comparative Tracking Index (CTI) | | | |
- |
*** V | IEC 60112 | |
Dielectric Strength |
*** kV/mm
| ASTM D149 | 23℃ , 1mm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
