Film Extrusion, Low/Medium Viscosity, Extrusion
| Original Document | Technical Datasheet(English) | |||
| Resin ID | PA410 | |||
| Features | Bio-basedLow viscosityMedium viscosity | |||
| Processing | InjectionExtrusionFilm Extrusion | |||
| Diagrams | Viscosity-shear rateShearstress-shear rate | |||
| Biobased/Renewable | Yes | |||
| Physical | Dry/Cond.(Sign in to View) | Unit | Test Standard | Test Condition |
|---|---|---|---|---|
Density/Specific Gravity | ***/ *** | g/cm³ | ISO 1183 | |
Melt Volume Flow Rate(MVR) | ||||
280°C/2.16 kg | ***/ * | cm³/10 min | ISO 1133 | |
Melt Mass Flow Rate(MFR) | ||||
280°C/2.16 kg | ***/ * | g/10 min | ISO 1133 | |
Water Absorption | ***/ * | % | ISO 62 | |
Moisture /Humidity Absorption | ***/ * | % | ISO 62 | |
Viscosity | ***/ * | cm³/g | ISO 307, 1157, 1628 | |
| Mechanical | Dry/Cond.(Sign in to View) | Unit | Test Standard | Test Condition |
Tensile Modulus | ***/ *** | Mpa | ISO 527-1/-2 | |
Tensile Strength | ||||
Break | ***/ *** | Mpa | ISO 527-1/-2 | |
Tensile Elongation | ||||
Yield | ***/ *** | % | ISO 527-1/-2 | |
Break | ***/ *** | % | ISO 527-1/-2 | |
| Impact | Dry/Cond.(Sign in to View) | Unit | Test Standard | Test Condition |
Charpy Notched Impact Strengh | ||||
-30℃ (-22℉) | ***/ *** | kJ/m² | ISO 179/1eA | |
23℃ (73℉) | ***/ *** | kJ/m² | ISO 179/1eA | |
Charpy Unnotched Impact Strengh | ||||
23℃ (73℉) | ***/ *** | kJ/m² | ISO 179/1eU | |
| Thermal | Dry/Cond.(Sign in to View) | Unit | Test Standard | Test Condition |
Melt Temperature(Tm) | ***/ * | °C | ISO 11357-1/-3 | 10°C/min |
| Electrical | Dry/Cond.(Sign in to View) | Unit | Test Standard | Test Condition |
Dielectric Constant(Permittivity) | ||||
5 GHz | ***/ *** | - | IEC 61189-2-721 | |
Dissipation Factor | ||||
5 GHz | ***/ *** | E-4 | IEC 61189-2-721 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
