ALTUGLAS™ R-Life V825T RED CR50 is an injection grade acrylic resins with applicability in automotive rear lighting applications.
It is made with 50% of recycled MMA monomer obtained by depolymerization of pre- and post-consumer waste streams according to ISO 14021 to lower the CO2 footprint, while meeting the same demanding requirements as its all-prime counterpart (outstanding optical properties, hardness, stiffness, UV stability, lightweight).
| Original Document | Technical Datasheet(English) | |||
| Availability | AsiaEurope | |||
| Features | UV StabiltiyWeather ResistanceRecycled Contained | |||
| Applications | Rear Lamp Housings | |||
| Markets | Automotive | |||
| Appearance | Pellets/GranulesRed | |||
| Processing | Injection | |||
| Automotive Specs | Renault-Nissan(RNPO) EP10-1B | |||
| Recycled Content | 50% Unspecified Recycled | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/3.8 kg | *** g/10 min | ISO 1133 | |
Mold Shrinkage | |||
Flow | ***~*** % | ASTM D955 | |
Water Absorption | *** % | ISO 62 | Equilibrium, 23°C, 50% RH |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 527-2/5 | 23°C |
Tensile Elongation | |||
Break | *** % | ISO 527-2/5 | 23°C |
Flexural Modulus | *** Mpa | ISO 178 | 23°C |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | |
Charpy Unnotched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eU | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell M | *** M | ASTM D 785 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75-2/A | Annealed |
Vicat Softening Temperature(VST) | *** °C | ISO 306/B50 | |
Coefficient of Linear Thermal Expansion | |||
Flow | *** E-6/°C | ASTM D 696 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
