SustaPEEK is a semi-crystalline, thermoplastic high-performance material. We process the high-performance plastic SustaPEEK as semi-finished products in the form of sheets, round rods and tubes as well as machined components.
Typical characteristics
- Flame retardant
- Self-extinguishing
- Good dimensional stability
- Low smoke density
Typical industries
- Electronics
- Healthcare
- Aerospace
- Mechanical Engineering Industry
- Oil and Gas
- Semiconductor factory equipment
| Original Document | Technical Datasheet(English) | |||
| Features | Flame RetardantDimensional StabilityLow Smoke Density | |||
| Markets | HealthcareElectrical / ElectronicsMechanical Engineering IndustrySemiconductor IndustryOil and GasAerospace | |||
| Appearance | SheetRodpipeNatural Color | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Water Absorption | *** % | ISO 62 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | |
Tensile Strength | |||
Yield | *** Mpa | ISO 527 | |
Tensile Elongation | |||
Break | *** % | ISO 527 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75/A | |
Specific Heat | *** J/kg-K | DIN 52612 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/K | DIN 53752 | |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | |
Thermal Conductivity | *** W/(m K) | DIN 52612-1 | |
Continuous Use Temperature | |||
Long term | ***~*** °C | Internal | long term |
Temperature at Short Circle Operation | *** °C | Internal | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-0 | *** mm | UL94 | |
V-0 | *** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | IEC 62631-3-1 | |
Surface Resistivity | *** Ohm | IEC 62631-3-2 | |
Dielectric Constant(Permittivity) | |||
- | *** - | IEC 60250 | |
Dissipation Factor | |||
50 Hz | *** E-4 | IEC 60250 | |
Dielectric Strength | *** kV/mm | IEC 60243 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
