Eltex® TUB121N3000 is a high-density polyethylene copolymer designed for the extrusion of large diameter pressure pipes. It is classified PE 100 in accordance with ISO 12162 based on ISO 9080 analysis.
Characteristics
• PE 100 Black pipe compound
Applications
• Gas
• Water
• Industrial
| Original Document | Technical Datasheet(English) | |||
| Features | Copolymer | |||
| Applications | Pressure Pipes | |||
| Appearance | Pellets/GranulesBlack | |||
| Processing | ExtrusionTube Extrusion | |||
| Reinforced | 2~2.5% Carbon black | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | pigmented |
Melt Mass Flow Rate(MFR) | |||
190℃/5 kg | *** g/10 min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2 | 23°C @ 1 mm/min |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2 | 23°C @ 50 mm/min |
Tensile Elongation | |||
Break | *** % | ISO 527-2 | 23°C @ 50 mm/min |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306 | 1 kg |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Oxidative Induction Time | *** Min | ISO 11357 | 210°C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
