Pro-fax EP649U high melt flow, impact polypropylene copolymer is available in pellet form. This resin is typically used in thin-wall injection molding applications and offers a very good stiffness/impact balance.
| Original Document | Technical Datasheet(English) | |||
| Status | Commercial: Active | |||
| Availability | North America | |||
| Features | Good StiffnessStiffness/Impact BalanceGood Impact ResistanceHigh FlowNucleated | |||
| Additive | Antistatic Additive | |||
| Applications | Thin wall injection molding | |||
| Markets | Rigid PackagingConsumer Products | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ASTM D 1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | 50 mm/min |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | 1.3 mm/min, 1% Secant, Procedure A |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
23℃ (73℉) | *** J/m | ASTM D256 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | Unannealed |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
