An economical commercial paper grade.
Tufnol Grade 1P/13 is a low cost commercial paper based laminate, produced to meet the need for an economical material where electrical requirements are moderate. As a good basic, low voltage insulation material, this grade has a higher mechanical strength than the other grades in our phenolic paper range and greater impact strength. It can be machined readily and components can be hot punched in thicknesses up to 3.2mm.
What is Grade 1P/13 used for?
This material is used for many electrical components where low voltage insulation is required. In addition, the low cost and all round properties of Grade 1 P.13 make it a popular choice for many less demanding mechanical duties. Consequently, it is used for a multitude of different engineering parts, such as spacers, base plates, side plates, and simple jigs and fixtures, in addition to the usual range of electrical insulation components.
Standards
Sheet: BS EN 60893-3-4 Type PF CP 201
Rod from Sheet: 60893-3-4:2012 PF CP 201
| Original Document | Technical Datasheet(English) | |||
| Appearance | SheetNatural ColorBlack | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | |
Water Absorption | *** mg | - | 1.6mm thk. |
Water Absorption | *** mg | - | 12mm thk. |
Water Absorption | *** mg | - | 3mm thk. |
Water Absorption | *** mg | - | 6mm thk. |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | Internal | |
Young’s modulus | *** Mpa | Internal | |
Shear Strength | *** Mpa | Internal | flatwise |
Cross breaking strength | *** Mpa | Internal | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
- | *** kJ/m² | Internal | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Continuous Use Temperature | |||
Long term | *** °C | Internal | |
Temperature at Short Circle Operation | *** °C | Internal | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Dielectric Constant(Permittivity) | |||
1MHz | *** - | Internal | |
Dissipation Factor | |||
1MHz | *** E-4 | Internal | |
Dielectric Strength | *** kV/mm | Internal | 1.6mm thk. flatwise in oil at 90°C |
Dielectric Strength | *** kV/mm | Internal | 3mm thk. flatwise in oil at 90°C |
Dielectric Strength | *** kV/mm | Internal | 6mm thk. flatwise in oil at 90°C |
Dielectric Strength | *** kV/mm | Internal | edgewise in oil at 90°C |
Insulation Resistance | *** Ohm | Internal | immersion in water |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
