Lotrène Q1018 Series are Linear Low Density Polyethylene resins produced in a gas phase reactor using butene (C4) co-monomer.
They are designed for blown film applications and can be used in pure form as well as blended with other PE resins, such as LDPE or HDPE and mPE resins for mono extrusion or co-extrusion process to modify film properties. Lotrène Q1018 Series are suited for many applications in the field of consumer, agricultural, industrial, food or hygiene packaging, for example: collation shrink, liners, FFS bags, heavy duty sacks, refuse, tunnel films, mulching films...
| Original Document | Technical Datasheet(English) | |||
| Features | Food Contact | |||
| Applications | Heavy duty BagsFilmBagsCompounding/BlendingFood PackagingPackaging | |||
| Processing | Film ExtrusionBlown FilmCo-extrusionCompounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | A120 |
Freezing temperature | *** °C | Internal | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 40 µm, Blown Film |
Gloss | *** - | ASTM D 2457 | 45°, 40 µm, Blown Film |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tested Film Thickness | *** μm | Internal | Blown Film |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD |
Yield | *** Mpa | ASTM D 882 | TD |
Break | *** Mpa | ASTM D 882 | MD |
Break | *** Mpa | ASTM D 882 | TD |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD |
Break | *** % | ASTM D 882 | TD |
Elmondorf Tear | *** N/mm | ASTM D 1922 | MD |
Elmondorf Tear | *** g | ASTM D 1922 | MD |
Elmondorf Tear | *** N/mm | ASTM D 1922 | TD |
Elmondorf Tear | *** g | ASTM D 1922 | TD |
Secant Modulus | *** Mpa | ASTM D 882 | MD,1% Secant |
Secant Modulus | *** Mpa | ASTM D 882 | TD, 1% Secant |
Dart Drop Impact | *** g | ASTM D 1709 | F50 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
