PLEXIGLAS® 8H is an amorphous thermoplastic molding compound (PMMA).
Typical properties of PLEXIGLAS® molding compounds are:
• good flow
• high mechanical strength, surface hardness and mar resistance
• high light transmission
• very good weather resistance
• free colorability due to crystal clarity.
Special properties of PLEXIGLAS® 8H molding compound are:
• optimum mechanical properties
• increased heat deflection temperature
• high melt strength
• AMECA listing.
Application:
Used for extruding optical and technical profiles and sheets.
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceLight TransmissionGood ColoringAnti-ScratchWeather ResistanceGood FlowHigh melt strength | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | ExtrusionSheet ExtrusionProfile Extrusion | |||
| Compliance | AMECA | |||
| Diagrams | Viscosity-shear rateShearstress-shear rateDynamic Shear modulus (G storage)-temperatureStress-strainSecant modulus-strainStress-strain (isochronous)(Creep) 23°CCreep modulus-time 23°CTensile modulus-temperature | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Volume Flow Rate(MVR) | |||
230℃/3.8 kg | *** cm³/10 min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | 1 mm/min |
Tensile Strength | |||
Break | *** Mpa | ISO 527 | 5 mm/min |
Tensile Elongation | |||
Break | *** % | ISO 527 | 5 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Unnotched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eU | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/B50 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/K | ISO 11359 | 0 - 50°C |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
HB | *** mm | IEC 60695-11-10 | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Light Transmission | *** % | ISO 13468-2 | 3 mm, D65 |
Refractive Index | *** - | ISO 489 | 3 mm, 589nm/23°C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
