Kraton MD6684 GS-N is a clear linear triblock copolymer based on styrene and ethylene/butylene (S-E/B-S) with bound styrene of 32.9% mass and 1% maleic anhydride. It is supplied from Eruope as identified in the grade nomenclature below.
Kraton MD6684 GS-N is used as a modifier of polymers. It is also suitable as an ingredient in formulating compounds for footwear applications and may be used in formulating adhesives, sealants and coatings.
Note: This Kraton polymer product is a development product. Thus, its properties and chemical composition may change based on market feedback. Kraton Polymers reserves the right to change specifications and/or discontinue production of the product.
| Original Document | Technical Datasheet(English) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 2781 | |
Melt Mass Flow Rate(MFR) | |||
230°C/5 kg | *** g/10 min | ISO 1133 | |
Viscosity | ***~*** Pa-s | Internal | Vis, Sol (Toluene) 25.0%w @25C |
Total Volatiles | *** % | Internal | 3h/110°C |
Filled/Ash | *** % | ISO 247 | Measured on the base polymer before functionalisation |
Maleic Anhydride Content | ***~*** % | Internal | |
Styrene Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | MD |
- | *** Mpa | ISO 37 | TD |
Tensile Elongation | |||
Break | *** % | ISO 37 | MD |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 10s |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Yellowness Index | *** - | ASTM E 313 | |
Total Extractables | *** % | Internal | in Methanol |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
