Kraton D1118 E is a clear, diblock copolymer based on styrene and butadiene with a polystyrene content of 33%. It is supplied from Europe in the physical form identified below.
Kraton D1118 ET - supplied as porous pellets dusted with talc
Kraton D1118 ES - supplied as porous pellets dusted with amorphous silica
Kraton D1118 ESM - supplied as powder dusted with amorphous silica
Kraton D1118 ETM - supplied as powder dusted with talc for the North American market
Kraton D1118 E is used for modification of bitumen. It may also be suitable for use in formulating adhesives, sealants and coatings, and in the modification of polymers.
| Original Document | Technical Datasheet(English) | |||
| Additive | Antioxidant | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | Compounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 2781 | |
Viscosity | ***~*** Pa-s | Internal | Vis, Sol (Toluene) 25.0%w @25C |
Total Volatiles | *** % | Internal | |
Filled/Ash | ***~*** % | Internal | ETM |
Filled/Ash | ***~*** % | ISO 247 | ES |
Filled/Ash | ***~*** % | ISO 247 | ESM |
Filled/Ash | ***~*** % | ISO 247 | ET |
Styrene Content | ***~*** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | |
at 300% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
Break | *** % | ISO 37 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 10s |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Total Extractables | *** % | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
