Kraton D1101 A polymer is a clear, linear block copolymer based on styrene and butadiene with bound styrene of 31% mass. It is supplied from Europe in the physical forms identified as follows in the grade nomenclature:
D1101 AT - supplied as porous pellets dusted with talc
D1101 AS - supplied as porous pellets dusted with amorphous silica
D1101 AU - supplied as porous pellets undusted
D1101 ASM - supplied as powder dusted with amorphous silica
D1101 AIM - supplied as powder dusted with calcium carbonate for supply to the North American market
Kraton D1101 A polymer is used as a modifier of bitumen in roofing felt compounds, roads and pipe coating. It may also be suitable for use in formulating adhesives, sealants and coatings and in the modification of polymers.
| Original Document | Technical Datasheet(English) | |||
| Additive | Antioxidant | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | Compounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
200 ℃/5 Kg | *** g/10 min | ISO 1133 | |
Viscosity | ***~*** Pa-s | Internal | Vis, Sol (Toluene) 25.0%w @25C |
Bulk(Apparent ) Density | *** g/cm³ | ASTM D 1895 | |
Total Volatiles | *** % | Internal | |
Filled/Ash | ***~*** % | ISO 247 | AIM |
Filled/Ash | *** % | ISO 247 | AS |
Filled/Ash | ***~*** % | ISO 247 | ASM |
Filled/Ash | *** % | ISO 247 | AT |
Filled/Ash | *** % | ISO 247 | AU |
Styrene Content | ***~*** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | Measured on films cast from a solution in toluene |
at 300% strain | *** Mpa | ISO 37 | Measured on films cast from a solution in toluene |
Tensile Elongation | |||
Break | *** % | ISO 37 | Measured on films cast from a solution in toluene |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 30s |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Total Extractables | *** % | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
