Kraton D1161 P is a clear, linear triblock copolymer based on styrene and isoprene, with a polystyrene content of 15%. It is supplied from North America in the physical form identified below.
Kraton D1161 PT - supplied as a dusted dense pellet
Kraton D1161 PTM - supplied as a dusted powder
Kraton D1161 P is used as an ingredient in formulating adhesives, sealants and coatings. It may also find use as a modifier of bitumen and polymers.
| Original Document | Technical Datasheet(English) | |||
| Additive | Antioxidant | |||
| Appearance | PowderClear/Transparent | |||
| Processing | Compounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
200 ℃/5 Kg | *** g/10 min | ASTM D 1238 | |
Viscosity | *** Cps | Internal | 25%w toluene solution at 25C |
Viscosity | ***~*** Cps | Internal | Sales Specification |
Total Volatiles | *** % | Internal | |
Filled/Ash | ***~*** % | Internal | Talc |
Filled/Ash | ***~*** % | ISO 247 | D1161 PTM milled in Europe |
Styrene Content | ***~*** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** psi | ASTM D 412 | Measured on films cast from a solution in toluene |
at 300% strain | *** psi | ASTM D 412 | Measured on films cast from a solution in toluene |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | Measured on films cast from a solution in toluene |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 10s |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Total Extractables | *** % | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
