Description
Revolve PA RDN is a rotational moulding polyamide 6 (PA6) designed to meet demanding requirements such as chemical resistance and low permeation to hydrocarbons (e.g. petrol).
The grade exhibits very high stiffness, good flow characteristics and high temperature resistance. The grade does not require any inert atmosphere during moulding and it is UV8
Features and Benefits
-High stiffness and hardness
-Good mouldability
-Low permeability to hydrocarbons
-Suitable for constant use up to 150ᵒC
-UV 8
Available as,
-Pre-dried natural powder
Typical applications,
-Fuel Tanks
-Chemical Tanks
-Hydraulic Fuel Tanks
| Original Document | Technical Datasheet(English) | |||
| Features | High Stiffness/RigidityHeat ResistanceEasy processingChemical ResistanceHydrocarbon ResistantGood FlowHigh Barrier property/Low permeation | |||
| Appearance | PowderNatural Color | |||
| Processing | Rotational Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ISO 527 | 50mm/min |
Tensile Elongation | |||
Break | *** % | ISO 527 | |
Flexural Modulus | *** Mpa | ISO 178 | 1.3mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Falling Dart Impact | *** J | ARM | 23°C, 3 mm |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ISO 75-2 | |
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75-3 | |
Vicat Softening Temperature(VST) | *** °C | ISO 306 | 50N |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
