PRE-ELEC® PE 17693 is a conductive flexible thermoplastic compound based on polyolefin elastomer with good low temperature properties. The conductivity is achieved by using special conductive carbon black. In addition to a low electrical resistivity, the product has excellent mechanical properties and is easy to extrude.
| Original Document | Technical Datasheet(English) PRE-ELEC Grade Selection | |||
| Features | Electrically Conductive | |||
| Processing | InjectionExtrusion | |||
| Reinforced | Carbon black | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/21.6 kg | *** g/10 min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | extruded tape; Thickness 600-800 µm |
Tensile Strength | |||
- | *** Mpa | ISO 527 | extruded tape; Thickness 600-800 µm |
Tensile Elongation | |||
Break | *** % | ISO 527 | extruded tape; Thickness 600-800 µm |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | extruded tape; Thickness 600-800 µm |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | Internal | extruded tape; Thickness 600-800 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
