Heromelt is the range of fluorinated thermoplastic polymers and their compounds that can be processed by melt extrusion, injection moulding and compression moulding. Heromelt FP Fluorothermoplastics (PFA, FEP, MFA and ETFE) are available as virgin polymers and as base polymers for tailor-made compounds.
These products have a wide range of technical and critical applications such as “off-shore” sealing elements, pumps and valves for chemical plants, wire and cable coatings and many other precision components.
MAIN BENEFITS
-Non-aging characteristics
-Chemical inertness
-Outstanding dielectric properties
-Heat resistance
-Toughness and flexibility
-Low Coefficient of Friction
-Non-stick properties
-Very low flammability
-Extreme temperature resistance -200° ÷250°C
-Outstanding weather resistance
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceGood Heat AgingWear/Abrasion ResistanceLow Friction/WearReleasability and Non-compatibilityWeather ResistanceChemical Resistance | |||
| Processing | InjectionExtrusionCompression MouldingResin Transfer Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | ***~*** g/cm³ | ASTM D4894 | |
Melt Mass Flow Rate(MFR) | |||
- | ***~*** g/10min | ASTM D1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | 23°C |
Tensile Strength | |||
- | ***~*** Mpa | ISO 527 | 23°C |
Tensile Elongation | |||
Break | *** % | ISO 527 | |
Flexural Modulus | ***~*** Mpa | ASTM D790 | |
Coefficient of Friction | ***~*** - | ISO 7148 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | ***~*** D | Internal | NEEDLE |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | ***~*** °C | ASTM D4591 | |
Temperature at Short Circle Operation | ***~*** °C | Internal | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Oxygen Index | *** % | ASTM D 2863 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Surface Resistivity | *** Ohm | Internal | |
Dissipation Factor | |||
- | ***~*** E-4 | ASTM D 150 | |
Dielectric Strength | ***~*** kV/mm | ISO 12086 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
