Base Polymer
Thermoplastic Vulcanisate (PP+EPDM)
Colour
natural color
Service Temperature
max. range (depending on load, geometry, etc.) -40-125 °C
Special Features
UV stabilised, good recovery, good weathering resistance, good chemical resistance, good ozone reistance, good hot air resistance, good hydrolysis resistant
Market Segment
Automotive, building and construction, electrical and electronic, Machinery, Furniture
Application Area
injection moulded parts
Typical Applications
seals, sealing lip, handles, soft touch elements, impact protection / shock absorber, protection caps, cable ducts, casters, plugs, fastener & connector, 2K components
Adhesion to
Polypropylene Homopolymer, Polypropylene Copolymer, Polyethylene, Thermoplastic Vulcanisate (PP+EPDM), Thermoplastic Olefin Elastomer, Thermoplastic Elastomer general
| Original Document | Technical Datasheet(English) Technical Datasheet(Chinese) | |||
| Features | Heat ResistanceUV StabiltiyWeather ResistanceOzone ResistantChemical ResistanceHydrolysis Resistance | |||
| Additive | UV-Stabilizer | |||
| Appearance | Pellets/GranulesNatural Color | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Spiral Flow | *** mm | - | 2.00 mm |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | Type 2 |
at 100% strain | *** Mpa | ISO 37 | Type 2 |
Tensile Elongation | |||
Break | *** % | ISO 37 | Type 2 |
Tear Strength | *** kN/m | ISO 34 | Method Ba |
Compression Set | *** % | ISO 815 | 100°C, 22 hr, Type A, 25% |
Compression Set | *** % | ISO 815 | 125°C, 72 hr, Type A, 25% |
Compression Set | *** % | ISO 815 | 22°C, 72 hr, Type A, 25% |
Compression Set | *** % | ISO 815 | 70°C, 22 hr, Type A, 25% |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 15 sec |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Processing Temperature | ***~*** °C | - | |
Mould temperature | ***~*** °C | - |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
