SUPEER™ Metallocene Linear Low Density Polyethylene (mLLDPE) 7358TA is a metallocene ethylene-hexene copolymer. It has a good processability and performs well in a wide range of general purpose and high performance cast film applications. Films produced with this grade offer good impact strength, puncture resistance, sealing and optical properties.
This product is not intended for and must not be used in any pharmaceutical/medical applications.
TYPICAL APPLICATIONS
SUPEER™ Metallocene Linear Low Density Polyethylene (mLLDPE) 7358TA is typically used for stretch and lamination films.
| Original Document | Technical Datasheet(English) | |||
| Processing | Cast Film | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | ASTM D3418 | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | |
Gloss | *** - | ASTM D 2457 | 45° |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 25 µm film |
Yield | *** Mpa | ASTM D 882 | TD, 25 µm film |
Break | *** Mpa | ASTM D 882 | MD, 25 µm film |
Break | *** Mpa | ASTM D 882 | TD, 25 µm film |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 25 µm film |
Break | *** % | ASTM D 882 | TD, 25 µm film |
Piercing strength | *** N | Internal | 25 µm film |
Puncture resistance | *** J | Internal | 25 µm film |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 25 µm film |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 25 µm film |
Dart Drop Impact | *** g | ASTM D 1709 | F50, 25 µm film |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
