FORTIFY™ Polyolefin Elastomer (POE) C11075DF
Ethylene octene copolymer produced by solution polymerization using metallocene catalyst for foaming FORTIFY™ Polyolefin Elastomer (POE) C11075DF is a grade typically used in foam application.
This grade is designed as a low density and high performance copolymer modifier to provide superior resilience and compression set properties.
TYPICAL APPLICATIONS
SABIC® FORTIFY™ C11075DF can be typically used for all types of foam, produced with chemical blowing agents or physical gases, X-linked and non Xlinked.
The main applications are:
Footwear, Sports & Leisure, Packaging, Building & Construction, Automotive.
Contact SABIC for detailed information about this resin and its applications.
This product is not intended for and must not be used in any pharmaceutical/medical applications.
| Original Document | Technical Datasheet(English) | |||
| Features | FoamableLow Density | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
230°C/2.16 kg | *** g/10min | ASTM D 1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant |
Tear Strength | *** kN/m | ASTM D 624 | Type C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 1 second |
Shore D hardness | *** D | ASTM D 2240 | 1 second |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | Peak |
Glass Transition Temperature | *** °C | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
