ICORENE® 1490 BLK 9001 is a UV stabilised linear medium density polyethylene black powder.
It has been developed for use as a powder in rotational moulding.
This grade is a very fast processing material which is very high in ESCR and cold impact strength. It is suitable for use in many different applications but especially where very fast pinhole removal is needed. It is easy to process with a low shrinkage tendency.
| Original Document | Technical Datasheet(English) | |||
| Features | Good StiffnessHigh Impact at Low TemperaturLow ShrinkageEasy processingUV StabiltiyESCRGood Flow | |||
| Additive | UV-Stabilizer | |||
| Appearance | PowderBlack | |||
| Processing | Rotational Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | 23°C |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | Condition B, 50°C, 10% Igepal, Rotational Molded, F50 |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | Condition B, 50°C, 100% Igepal, Rotational Molded, F50 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-1 | 23°C |
Tensile Strength | |||
Yield | *** Mpa | ISO 527 | 23°C |
Tensile Elongation | |||
Break | *** % | ISO 527-2 | 23°C |
Flexural Modulus | *** Mpa | ISO 178 | 23°C |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Falling Dart Impact | *** J/cm | Internal | -20°C, 3.20 mm, Rotomoul |
Falling Dart Impact | *** J/cm | ARM | -40°C, Rotomoulding |
Tensile Impact | *** kJ/m² | ISO 8256 | -30°C, Notched |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
