SABIC® LLDPE 118WJ is a butene linear low density polyethylene resin typically used for general purpose applications. Films produced from this resin are tough with good puncture resistance, high tensile strength and good hottack properties. The resin contains slip and antiblock additive. SABIC® LLDPE 118WJ is TNPP free.
This product is not intended for and must not be used in any pharmaceutical/medical applications.
TYPICAL APPLICATIONS
Shipping sacks, ice bags, frozen food bags, stretch wrap film, produce bags, liners, carrier bags, garbage bags, agricultural films, laminated and coextruded films for meat wrap, frozen food and other food packaging, shrink film (for blending with LDPE), industrial consumer packaging, and high clarity film applications if blended with (10~20%) LDPE.
| Original Document | Technical Datasheet(English) | |||
| Solutions | Foam & Lightweight | |||
| Additive | Slip agentAntiblock | |||
| Processing | Blown Film | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Coefficient of Friction | *** - | ASTM 1894 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306 | 10 N (VST/A) |
Melt Temperature(Tm) | *** °C | Internal | DSC melting point |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 30 μm film |
Gloss | *** % | ASTM D 2457 | 45° |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-3 | TD |
Break | *** Mpa | ISO 527-3 | MD |
Break | *** Mpa | ISO 527-3 | TD |
Tensile Elongation | |||
Break | *** % | ISO 527-3 | MD |
Break | *** % | ISO 527-3 | TD |
Tensile Modulus | *** Mpa | ISO 527-3 | MD |
Tensile Modulus | *** Mpa | ISO 527-3 | TD |
Elmondorf Tear | *** N/mm | ISO 6383-2 | MD |
Elmondorf Tear | *** N/mm | ISO 6383-2 | TD |
Dart Drop Impact | *** J/mm | ASTM D4272 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
