CirculenRenew C14 LD2420 K is part of the Circulen© product family of circular and sustainable solutions.
CirculenRenew C14 polymer reduces the carbon footprint as it replaces fossil feedstock through using renewable raw materials made from bio-based waste and residue oils. The renewable content of CirculenRenew C14 is measured by an accredited third party laboratory and stated as a parameter on the Certificate of Analysis (CoA).
CirculenRenew C14 LD2420 K is a drop-in solution and therefore doesn¶t require any adaptation of the existing processing equipment.
CirculenRenew C14 LD2420 K is a non-additivated, low density polyethylene. It is characterized by a good processability. Films made from CirculenRenew C14 LD2420 K exhibit good optical properties. It is delivered in pellet form.
This product is not intended for use in medical and pharmaceutical applications.
| Original Document | Technical Datasheet(English) | |||
| Features | Good optical propertiesBio-basedRenewable ResourceRecycled Contained | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | Cast FilmInjectionBlown FilmExtrusion Coating | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-1/-2 | |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-1/-2 | |
Coefficient of Friction | *** - | ISO 8295 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A50 | |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | Peak |
Processing Temperature | ***~*** °C | - | Blown Film Extrusion |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 50 µm |
Gloss | *** - | ASTM D 2457 | 20° |
Gloss | *** - | ASTM D 2457 | 60° |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 527-1/-3 | MD |
- | *** Mpa | ISO 527-1/-3 | TD |
Tensile Elongation | |||
Break | *** % | ISO 527-1/-3 | MD |
Break | *** % | ISO 527-1/-3 | TD |
Piercing strength | *** J/m | DIN 53373 | Film thickness: 70 µm |
Dart Drop Impact | *** g | ASTM D 1709 | F50 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
