Hydrogenated Styrenic Thermoplastic Elastomer (SEBS) Tuftec™ MP10
Asahi Kasei Tuftec™ MP10 is amine-modified SEBS. MP10 can be used as a modifier for engineering plastics such as polyamide (PA) or polyester (PEs), polylactic acid (PLA) and thermoplastic polyurethane (TPU). It is particularly suitable for an adhesive to TPU. It is also used as a compatibilizer of PS or olefinic resin and polar resins. It shows excellent adhesion to inorganic fillers, which can achieve good dispersion of inorganic fillers into plastics.
| Original Document | Technical Datasheet(English) Technical Datasheet(Chinese) | |||
| Appearance | Pellets/Granules | |||
| Processing | Compounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | Dumbbell: Type 1A 500 mm/min |
at 300% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
- | *** % | ISO 37 | Dumbbell: Type 1A 500 mm/min |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 7619 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
