Hydrogenated Styrenic Thermoplastic Eastomer (SEBS) Tuftec™ H1062
Asahi Kasei Tuftec™ H1062 is designed for an impact modifier of polypropylene (PP). It provides good balance of properties and can improve impact resistance property at room and low temperature. H1062 can be used as an additive to enhance heat sealability of PP film.
| Original Document | Technical Datasheet(English) Technical Datasheet(Chinese) | |||
| Features | High ImpactMedical Application/Health Care | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | Compounding | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | Dumbbell: Type 1A 500 mm/min |
at 300% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
- | *** % | ISO 37 | Dumbbell: Type 1A 500 mm/min |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 7619 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
