Primary Industry
-Aerospace
Description/Primary Uses
• Carbon-filled PEEK
• Bearings
Features & Benefits
• Bearing grade material
| Original Document | PEEK Products Table(English) Technical Datasheet(English) | |||
| Features | Flame RetardantWear/Abrasion ResistanceLow Friction/WearFilled & Reinforced | |||
| Appearance | Pellets/GranulesBlack | |||
| Processing | Injection | |||
| Reinforced | Carbon Fiber | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Water Absorption | *** % | ASTM D570 | 24 Hours |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 0.5% Secant |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
- | *** % | ASTM D 638 | |
Flexural Modulus | *** Mpa | ASTM D790 | 0.5% Secant |
Flexural Strength | |||
- | *** Mpa | ASTM D790 | |
Coefficient of Friction | *** - | ASTM G77 | PV=12,600 psi-ft/min |
Wear Factor | *** E-10 in3·min/ft·lb·hr | ASTM G77 | |
Compressive Strength | *** Mpa | ASTM D 695 | Break |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell M | *** M | ASTM D 785 | |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ASTM D648 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6 cm/cm/℃ | ASTM D 696 | Above 149°C |
- | *** E-6 cm/cm/℃ | ASTM D 696 | Below 149°C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
