Primary Industry
-Aerospace
Description/Primary Uses
• Glass-reinforced PEEK
• Higher strength/stiffness than unreinforced Arlon®, with excellent electrical and thermal isolation performance
• Landing gear
• Utility actuation
• Engines
• Engine sensor housings, valve housings
• Engine build-up components (brackets, cable clamps)
• Electrical connectors
Features & Benefits
• Meets MIL-P-46183, Type II, Class 3
• Exceptional chemical and thermal resistance
• Excellent wear grade material
• Excellent fire properties (low smoke/flammability, self-extinguishing)
• Good toughness/impact performance
• Service temperature range: -65°F (-54°C) to +500°F (260°C)
• Excellent chemical resistance to all aerospace fluids
| Original Document | Technical Datasheet(English) | |||
| Features | Good StiffnessGood Impact ResistanceHeat ResistanceThermal InsulationFlame RetardantInsulatingWear/Abrasion ResistanceLow Smoke DensityChemical ResistanceFilled & Reinforced | |||
| Appearance | Pellets/GranulesBrown | |||
| Processing | Injection | |||
| Reinforced | Glass Fiber | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 0.5% Secant |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
- | *** % | ASTM D 638 | |
Flexural Modulus | *** Mpa | ASTM D790 | 0.5% Secant |
Flexural Strength | |||
- | *** Mpa | ASTM D790 | |
Coefficient of Friction | *** - | ASTM G77 | PV = 12600 psi-ft/min |
Wear Factor | *** E-10 in3·min/ft·lb·hr | ASTM G77 | |
Shear Strength | *** Mpa | ASTM D 732 | Axial |
Shear Strength | *** Mpa | ASTM D 732 | Transverse |
Compressive Strength | *** Mpa | ASTM D 695 | Break |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell M | *** M | ASTM D 785 | |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ASTM D648 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6 cm/cm/℃ | ASTM E228 | Above 149°C |
- | *** E-6 cm/cm/℃ | ASTM E228 | Below 149°C |
Deformation | *** % | ASTM D621 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
