NEOFLON PFA AP-230SH is a high purity PFA with fully fluorinated. It is excellent in melt flowability. It is suitable for chemical liquid tubes of semiconductors by extrusion molding.
Introduction
- AP-230SH is a copolymer of tetrafluoroethylene and perfluoroalkylvinylether.
- High purity PFA with terminal groups fully fluorinated.
- Good melt flowability while maintaining excellent properties of PTFE. It can be melt-molded as a thermoplastic resin by extrusion molding.
- Suitable for extrusion molding and transfer molding. It is used for tubes, sheets and valve lining applications.
- Less fluoride ions due to the fluorinated terminal group.
- Excellent chemical resistance which is not affected by most of the chemicals.
- It retains flexibility without losing toughness under the environment from cryogenic to high temperature.
- Excellent heat resistance. Continuous use temperature is 260 ℃.
- Excellent weather resistance. No properties change even when exposed outside for a long time.
- Non-stickiness. It shows excellent releasability and water repellency / oil repellency.
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceWeather ResistanceChemical ResistanceGood Flow | |||
| Processing | ExtrusionTube Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
372°C/5.0 kg | *** g/10 min | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 1708 | |
Tensile Elongation | |||
- | *** % | ASTM D1708 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | DSC | |
Continuous Use Temperature | |||
Long term | *** °C | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
