NEOFLON PFA AP-202 is an ultra-high flowability fluororesin. It is suitable for extrusion molding of fine and thin wall electric wire
Introduction
- AP-202 is a copolymer of tetrafluoroethylene and perfluoroalkyl vinyl ether.
- Good melt flowability while maintaining excellent properties of PTFE. It can be melt-molded as a thermoplastic resin by injection molding and extrusion molding.
- Suitable for extrusion molding of extremely fine electric wires. It is also used for electric wires of personal computers and mobile phones.
- Excellent chemical resistance which is not affected by most of the chemicals.
- It retains flexibility without losing toughness under the environment from cryogenic to high temperature.
- Low dielectric constant and dielectric loss tangent in a wide range of temperature and frequency.
- It shows high electrical resistance and dielectric strength.
- Nonflammable like POLYFLON PTFE and NEOFLON FEP.
- Excellent weather resistance. No properties change even when exposed outside for a long time.
- Non-stickiness. It shows excellent releasability and water repellency / oil repellency.
| Original Document | Technical Datasheet(English) | |||
| Features | Flame RetardantLow DielectricWeather ResistanceChemical Resistance | |||
| Appearance | Pellets/Granules | |||
| Processing | InjectionExtrusionWire & Cable Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
- | *** g/10min | ASTM D3307 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 1708 | |
Tensile Elongation | |||
- | *** % | ASTM D1708 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
