NEOFLON FEP NP-20 is a melt processable fluoropolymer.
Introduction
- NEOFLON FEP NP-20 is a copolymer of tetrafluoroethylene and hexafluoropropylene.
- Quite similar properties as PTFE. Chemical, electrical and mechanical properties.
- Continuous service temperature is 200℃.
- Typical applications are wire and cable insulation, tubing, and film by extrusion process.
| Original Document | Technical Datasheet(English) | |||
| Appearance | Pellets/Granules | |||
| Processing | ExtrusionFilm ExtrusionTube ExtrusionWire & Cable Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
- | *** g/10min | ASTM D2116 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 638 | |
Tensile Elongation | |||
- | *** % | ASTM D 638 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | ASTM D2116 | |
Continuous Use Temperature | |||
Long term | *** °C | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
