DAI-EL G-704 is a fluoroelastomer which has good fluidity of molding.
Introduction
- DAI-EL G-704 is a cure-incorporated copolymer of vinylidene fluoride and hexafluoropropylene which has good fluidity of molding.
- It is suitable for injection molding and transfer molding.
| Original Document | Technical Datasheet(English) | |||
| Features | Good Flow | |||
| Processing | InjectionResin Transfer Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | 23°C |
Mooney Viscosity | *** MU | ASTM 1646 | 100°C, ML 1+10 |
Mooney Viscosity | *** MU | ASTM 1646 | 121°C, ML 1+10 |
Fluorine Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Compression Set | *** % | Internal | 70hrs@200°C, 25% compression |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 3sec |
Shore A hardness | *** A | ASTM D 2240 | peak |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Low Temp. Retraction | *** °C | ASTM D1329 | TR10 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
