DAI-EL G-802 is a fluoroelastomer which provides superior mechanical properties and resistance to steam and acids.
Introduction
- DAI-EL G-802 is a peroxide curable copolymer of vinylidene fluoride and hexafluoropropylene which is suitable for injection, transfer and extrusion molding.
- It provides superior mechanical properties and resistance to steam and acids compared with bisphenol curable products.
| Original Document | Technical Datasheet(English) | |||
| Features | Steam ResistantAcid Resistanc | |||
| Processing | InjectionExtrusionResin Transfer Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | 23°C |
Mooney Viscosity | *** MU | ASTM 1646 | 100°C, ML 1+10 |
Mooney Viscosity | *** MU | ASTM 1646 | 121°C, ML 1+10 |
Fluorine Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Compression Set | *** % | Internal | 70hrs@200°C, 25% compression |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 3sec |
Shore A hardness | *** A | ASTM D 2240 | peak |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Low Temp. Retraction | *** °C | ASTM D1329 | TR10 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
