DAI-EL G-501N is a fluoropolymer which provides a good balance of chemical resistance and cold temperature flexibility.
Introduction
- DAI-EL G-501N is a diamine curable terpolymer of vinylidene fluoride, tetrafluoroethylene and hexafluoropropylene which is suitable for compression molding.
- It provides a good balance of chemical resistance and cold temperature flexibility.
- Use it for adjustment of cure density by mixing with other bisphenol curable products. It does not contain vulcanization agent and accelerator.
| Original Document | Technical Datasheet(English) | |||
| Features | Good FlexibilityChemical Resistance | |||
| Processing | Compression Moulding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | 23°C |
Mooney Viscosity | *** MU | ASTM 1646 | 121°C, ML 1+10 |
Mooney Viscosity | *** MU | ASTM 1646 | 140°C, ML 1+10 |
Fluorine Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 3sec |
Shore A hardness | *** A | ASTM D 2240 | peak |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Low Temp. Retraction | *** °C | ASTM D1329 | TR10 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
