Roving Glass - PA6 Consolidated Composite Laminate
Tepex® is a group of composite semi-finished products that are fully impregnated, consolidated and plate-shaped. They are made of high-tensile continuous fibers (or long fibers in the case of Tepex® flowcore) and a thermoplastic matrix. These composite sheets can be processed into complex components in short cycle times through heating and subsequent forming.
| Original Document | Technical Datasheet(English) | |||
| Status | Business Restructured | |||
| Features | Filled & Reinforced | |||
| Appearance | Sheet | |||
| Reinforced | 47% Glass Fiber | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | Laminate density |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-4/5 | 23 °C, ISO 1110 |
Tensile Modulus | *** Mpa | ISO 527-4/5 | 23 °C, dry |
Tensile Strength | |||
- | *** Mpa | ISO 527-4/5 | 23 °C, ISO 1110 |
- | *** Mpa | ISO 527-4/5 | 23 °C, dry |
Tensile Elongation | |||
Break | *** % | ISO 527-4/5 | 23 °C, ISO 1110 |
Break | *** % | ISO 527-4/5 | 23 °C, dry |
Flexural Modulus | *** Mpa | ISO 14125 | 23 °C, ISO 1110 |
Flexural Modulus | *** Mpa | ISO 14125 | 23 °C, dry |
Flexural Strength | |||
- | *** Mpa | ISO 14125 | 23 °C, ISO 1110 |
- | *** Mpa | ISO 14125 | 23 °C, dry |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
- | *** °C | ISO 75-1/-3 | 19 GPa |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/K | ISO 11359-1/-2 | -35 °C to 23 °C, dry |
- | *** E-6/K | ISO 11359-1/-2 | 23 °C to 80 °C, dry |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | 10 K/min |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
