Type: Aromatic Polyether-based Thermoplastic Polyurethane (TPU)
Features: High moisture vapour transmission. Good low temperature properties and elasticity.
Process: Extrusion and Injection Molding.
| Original Document | Technical Datasheet(English) | |||
| Availability | AsiaEuropeNorth AmericaMiddle EastLatin AmericaAfricaAustralia and New ZealandSouth & Central America | |||
| Features | Medical Application/Health Care | |||
| Processing | InjectionExtrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Abrasion resistance | *** mg | ASTM D 3389 | H18, 1000g |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
at 300% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Tear Strength | *** N/mm | ASTM D 624 | Graves, Die C |
Tear Strength | *** N/mm | ASTM D 470 | Trouser |
Tensile Set | *** % | ASTM D 412 | 200% elongation |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | Kofler Melt Point |
Melt Temperature(Tm) | *** °C | DSC | |
Glass Transition Temperature | *** °C | DSC | |
| Aging | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Change in Volume | *** % | ASTM D471 | Swell in Water (24h/23C) |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Water Vapor Transmission Rate | *** g/m²/24 hr | ASTM E96 | upright cup (23°C, 50%RH) |
Water Vapor Transmission Rate | *** g/m²/24 hr | ASTM D6701 | Mocon (38°, 90%RH) |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
