Type:
Pellethane 2363-90A is a thermoplastic polyurethane elastomer
Features:
USP Class VI
Pellethane® thermoplastic polyurethanes (TPUs) offer a wide range of properties for medical and healthcare products. These medical grade polymers are available as aromatic polyether and polyesters and are known for their flexibility and wide range of hardnesses. Pellethane TPUs are ideal for a variety of medical applications including tubing, catheters, and other short-term uses.
| Original Document | Technical Datasheet(English) | |||
| Availability | AsiaEuropeNorth AmericaMiddle EastLatin AmericaAfricaAustralia and New ZealandSouth & Central America | |||
| Features | Medical Application/Health Care | |||
| Processing | InjectionExtrusion | |||
| Compliance | USP Class VI | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
224℃/2.16 kg | *** g/10 min | ASTM D 1238 | |
Mold Shrinkage | |||
Flow | ***~*** % | ASTM D955 | 1.6 mm |
Across Flow | ***~*** % | ASTM D955 | 1.6 mm |
Abrasion resistance | *** mg | ASTM D 1044 | 1000g, 1000 cycles; H-22 wheel (coarser) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D 412 | |
at 50% strain | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
at 300% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Flexural Modulus | *** Mpa | ISO 178 | |
Tear Strength | *** kN/m | ASTM D 624 | Die C |
Compression Set | *** % | ASTM D 395 | 22 hrs @ 25°C |
Compression Set | *** % | ASTM D 395 | 22 hrs @ 70°C |
Elongation Set After Break | *** % | ASTM D 412 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/°C | ASTM D 696 | |
Glass Transition Temperature | *** °C | DSC | |
Processing Temperature | ***~*** °C | - | Molding |
Mould temperature | ***~*** °C | - |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
