SYLGARD™ 186 Silicone Elastomer is a two-part, 10:1 mix, translucent encapsulant with high tear strength
Features & Benefits
• 10:1 mix ratio • High viscosity • RT and heat cure • High tear strength • UL tested • Rapid, versatile cure processing controlled by temperature • Can be considered for uses requiring UL requirements
Applications
• General potting applications • Power supplies • Connectors • Sensors • Industrial controls • Transformers • Amplifiers • High voltage resistor packs • Relays • Adhesive/encapsulant for solar cells • Adhesive handling beam lead integrated circuits during processing
| Original Document | Technical Datasheet(English) | |||
| Appearance | Translucent | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | Cured |
Viscosity | *** Pa-s | Internal | Mixed |
Viscosity | *** Pa-s | Internal | Part A or Base |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | Internal | |
Tensile Elongation | |||
- | *** % | Internal | |
Tear Strength | *** N/mm | Internal | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | Internal | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | Internal | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-1 | *** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | Internal | |
Dielectric Constant(Permittivity) | |||
100Hz | *** - | ASTM D 150 | |
100 kHz | *** - | ASTM D 150 | |
Dissipation Factor | |||
100Hz | *** E-4 | ASTM D 150 | |
100 kHz | *** E-4 | ASTM D 150 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
