Two-part, 1:1 mix, gray, general purpose encapsulant with good flowability and flame resistance and faster cure at room temperature
FEATURES & BENEFITS
• Good flowability • Low cost for silicone benefits • Rapid room temp or heat accelerated cure • Moderate thermal conductivity • UL 94 V-0 flammability rating • Rapid, versatile cure processing controlled by temperature • Shorter room temp cure reduces cycle time • Can be considered for uses requiring added flame resistance
APPLICATIONS
• SYLGARD™ 164 Silicone Elastomer is suitable for general potting material for power supplies, connectors, sensors, industrial controls, transformers, amplifiers, high voltage resistor packs and relays.
| Original Document | Technical Datasheet(English) | |||
| Features | Thermal ConductiveFlame RetardantGood Flow | |||
| Appearance | Gray Color | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | Uncured Part A or Base |
Density/Specific Gravity | *** g/cm³ | Internal | Uncured Part B or Catalyst |
Viscosity | *** Pa-s | Internal | Part A or Base |
Viscosity | *** Pa-s | Internal | Part B or Catalyst |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tear Strength | *** N/mm | Internal | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | Internal | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Relative Temperature Index(RTI), Imp | |||
- | *** °C | UL 746 | |
Relative Temperature Index(RTI), Elec | |||
- | *** °C | UL 746 | |
Relative Temperature Index(RTI), Str | |||
- | *** °C | UL 746 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/°C | TMA | |
Thermal Conductivity | *** W/(m K) | - | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-0 | *** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | Internal | |
Dielectric Constant(Permittivity) | |||
100Hz | *** - | ASTM D 150 | |
100 kHz | *** - | ASTM D 150 | |
Dissipation Factor | |||
100Hz | *** E-4 | ASTM D 150 | |
100 kHz | *** E-4 | ASTM D 150 | |
Dielectric Strength | *** kV/mm | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
