Special,high flow SEBS series for injection moulding
Additive Packages
Heat and UV stabilizer and lubricant
Features
-Rubberlike elasticity
-Ease of coloring by proper MB (PE, PP, etc. based)
-Ease of processing (no pre-drying requested)
-Recyclability
| Original Document | Technical Datasheet(English) | |||
| Features | Good ColoringEasy processingUV StabiltiyOzone ResistantHydrolysis ResistanceAcid ResistancOil ResistantAlcohol ResistantDetergent resistantHigh Flow | |||
| Additive | UV-StabilizerHeat StabilizerLubricant | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 37 | |
at 100% strain | *** Mpa | ISO 37 | |
at 300% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
Break | *** % | ISO 37 | |
Tear Strength | *** kN/m | ISO 34 | Perpendicular to flow |
Compression Set | *** % | ASTM D 395 | 22h/70°C |
Compression Set | *** % | ASTM D 395 | 72h/23°C |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | Internal | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 3 second |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Continuous Use Temperature | |||
Long term | *** °C | Internal | Max. Dynamic Service Temperature |
Temperature at Short Circle Operation | *** °C | Internal | Max. Static Service Temperature |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
