Enflex V1055A TPV (thermoplastic vulcanizate) is a general purpose EPDM/PP compound available in both natural and black. It is designed to replace thermoset elastomers such as EPDM or polychloroprene, and traditional thermoplastic TPVs. Enflex V grades provide the performance of vulcanized rubber with the advantage of low-cost thermoplastic processing.
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceEasy processingUV StabiltiyOzone ResistantAcid ResistancAlkali resistanceOil ResistantAlcohol ResistantAnti-SolventDetergent resistant | |||
| Appearance | Natural ColorBlack | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Tear Strength | *** kN/m | ASTM D 624 | Die C |
Compression Set | *** % | ASTM D 395 | 22h / 70℃ |
Compression Set | *** % | ASTM D 395 | 70h / 125℃ |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | Extruded, 5 sec |
Shore A hardness | *** A | ASTM D 2240 | Injection Molded, 5 sec |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Continuous Use Temperature | |||
Long term | *** °C | Internal | Dynamic Service Temperature |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
