Ingeo 2500HP is a high viscosity product from NatureWorks LLC, designed for extrusion applications. It is designed to crystallize during processing, leading to higher heat deflection temperatures in opaque applications. See table at right for properties.
Applications
The variety of products made with 2500HP is widely varied and growing. Applications include crystalline sheet for cards, graphic arts and signage.
| Original Document | Technical Datasheet(English) | |||
| Features | Bio-basedRenewable ResourceDegradableFood ContactHigh Viscosity | |||
| Processing | Extrusion | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
210℃/2.16kg | *** g/10 min | ASTM D 1238 | |
Mold Shrinkage | |||
- | ***~*** % | Internal | molded amorphous with 26°C mold temperature |
- | ***~*** % | Internal | molded crystalline with 120°C mold temperature |
Viscosity | *** - | ASTM D5225 | Relative viscosity |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | molded amorphous with 26°C mold temperature |
Yield | *** Mpa | ASTM D638 | molded crystalline with 120°C mold temperature |
Tensile Elongation | |||
- | *** % | ASTM D 638 | molded amorphous with 26°C mold temperature |
- | *** % | ASTM D 638 | molded crystalline with 120°C mold temperature |
Flexural Modulus | *** Mpa | ASTM D790 | molded amorphous with 26°C mold temperature |
Flexural Modulus | *** Mpa | ASTM D790 | molded crystalline with 120°C mold temperature |
Flexural Strength | |||
- | *** Mpa | ASTM D790 | molded amorphous with 26°C mold temperature |
- | *** Mpa | ASTM D790 | molded crystalline with 120°C mold temperature |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
- | *** J/m | ASTM D 256 | molded amorphous with 26°C mold temperature |
- | *** J/m | ASTM D 256 | molded crystalline with 120°C mold temperature |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | molded crystalline with 120°C mold temperature |
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM E2092 | molded amorphous with 26°C mold temperature |
Freezing temperature | ***~*** °C | Internal | molded crystalline with 120°C mold temperature |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
