This high density polyethylene is an ethylene-hexene copolymer that is tailored for injection molded applications that require:
•Moderate flow
• Excellent impact strength
• Good stiffness
• Durability
Typical injection molded applications for 9006 include:
• Industrial pails (five-gallon)
• Pail lids
• Automotive applications
• Foamed parts
This resin meets these specifications:
• ASTM D4976 - PE 233
• FDA 21 CFR 177.1520(c) 3.2a, use conditions B through H per 21 CFR 176.170(c)
| Original Document | Technical Datasheet(English) | |||
| Features | Good StiffnessDurabilityGood Impact ResistanceGood Flow | |||
| Processing | Injection | |||
| Compliance | ASTM D4976FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | Condition B (100 % Igepal), F50 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | 2 in/min, Type IV bar |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 2 in/min, Type IV bar |
Flexural Modulus | *** Mpa | ASTM D790 | Tangent - 16:1 span:depth, 0.5 in/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | Type A, Type I specimen |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | Loading 1, Rate A |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
