Yellowstripe® 8300 Pipe meets or exceeds:
-ASTM D2513
-CAN/CSA-B137.4
-UPC
-ASTM D3350, cell classification PE445574C and PE445576C
-PPI TR-4 designation PE4710 and PE100
Yellowstripe® 8300 Pipe for:
Natural Gas Distribution, LPG and Propane Gas Distribution, Yard Gas Iron Pipe Size OD (IPS) ½” to 24” Copper Tube Size OD (CTS) ½” to 1 ¼” Coils available up through 6”
Outdoor Storage up to Ten (10) years per ASTM D2513
| Original Document | Technical Datasheet(English) | |||
| Appearance | pipe | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/21.6 kg | *** g/10 min | ASTM D 1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** psi | ASTM D638 | Type IV |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 2 in / min., Type IV Bar |
Flexural Modulus | *** psi | ASTM D790 | 2% Strain |
Notch Pipe Test | *** hr | ASTM F1473 | PENT |
Resistance to rapid crack propagation | *** bar | ISO 13478 | Full Scale, 0ºC |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °F | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °F | ASTM D1525 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-4/°F | ASTM D 696 | |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Minimum Required Strength(MRS) | *** MPa | ISO 9080 | 20ºC |
Hydrostatic Design Basis | *** psi | ASTM D2837 | 23º C |
Hydrostatic Design Basis | *** psi | ASTM D2837 | 60º C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
