432G is low-density polyethylene resins for protective films. This grade is designed to be processed in conventional blown or cast film equipment.
Characteristics
▶ Low gel(fish eye) content
▶ Excellent optical property (Transparency, Gloss)
▶ Good processability
▶ No additives
Applications
▶ Protective film
▶ Shrinkage film
| Original Document | Technical Datasheet(English) | |||
| Appearance | Clear/Transparent | |||
| Processing | Cast FilmBlown Film | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** kg/cm² | ASTM D638 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | |
Coefficient of Friction | *** - | ASTM 1894 | 40㎛ Film |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | 1kg |
Melt Temperature(Tm) | *** °C | Internal | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 40㎛ Film |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** kg/cm² | ASTM D 882 | MD, 40㎛ Film |
Break | *** kg/cm² | ASTM D 882 | TD, 40㎛ Film |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 40㎛ Film |
Break | *** % | ASTM D 882 | TD, 40㎛ Film |
Dart Drop Impact | *** g | ASTM D 1709 | 40㎛ Film |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
