Free-flowing suspension PTFE for general compression moulding of applications like seals, shaped parts and automatically or isostatically moulded articles.
Special Features:
Meets ASTM D 4894 Type IV, Grade 2 classification
Produced by suspension polymerisation
Good mould filling behaviour
Very good free-flowing properties
Good mechanical properties
Low shrinkage
Excellent chemical inertness
Low friction behaviour
Good flame retardance
Exceptional temperature resistance
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceFlame RetardantWear/Abrasion ResistanceLow Friction/WearLow ShrinkageGood MoldabilityChemical Resistance | |||
| Appearance | Powder | |||
| Processing | Compression Moulding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 12086 | |
Mold Shrinkage | |||
- | *** % | Internal | Cylinder 45 mm diameter |
Particle Size | *** micrometer | ISO 13320-1 | |
Bulk(Apparent ) Density | *** g/cm³ | ISO 60 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Coefficient of Linear Thermal Expansion | |||
Flow | *** E-6/K | DIN 53752 | 30 - 100 °C |
Flow | *** E-6/K | DIN 53752 | 30 - 200 °C |
Flow | *** E-6/K | DIN 53752 | 30 - 260 °C |
Thermal Conductivity | *** W/(m K) | DIN 52612-1 | |
Deformation | *** % | ASTM D621 | 15 MPa, 100 h |
Deformation | *** % | ASTM D621 | 15 MPa, 24 h |
Deformation | *** % | ASTM D621 | 15 MPa, permanent |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-0 | *** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | IEC 60093 | |
Surface Resistivity | *** Ohm | IEC 60093 | |
Dielectric Strength | *** kV/mm | ISO 12086 | 0.2 mm film |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 527-3 | 0.2 mm film |
Tensile Elongation | |||
Break | *** % | ISO 527-3 | 0.2 mm film |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
