3MDyneon Fluoroelastomer FG 5690Q is a dipolymer of vinylidene fluoride and hexafluoropropylene with proprietary incorporated cure technology.
Features and Benefits
• High viscosity version of 3M™ Dyneon™ Fluoroelastomer FG 5630Q • In compliance with FDA regulation 21 CFR 177.2600 for use in the production of rubber articles intended for repeated use in contact with food when used at no more than 60% by weight in the final compound, and properly post-cured for 16 hours at 230°C. • When compared to diamine cured compounds this product gives: - Excellent mold release - Better mold flow - Outstanding compression set resistance - Excellent water resistance at elevated temperatures • Process targets: Compression molding
Typical Applications
• Recommended for O-rings with direct food contact • Molded shapes, composites
| Original Document | Technical Datasheet(English) | |||
| Features | Mold ReleaseFood ContactHydrolysis ResistanceGood FlowHigh Viscosity | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | |
Mooney Viscosity | *** MU | Internal | ML 1 + 10 @ 121ºC |
Fluorine Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Compression Set | *** % | ASTM D1414 | 230°C, 16 hr |
Compression Set | *** % | ASTM D1414 | 260°C, 24 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Low Temp. Retraction | *** °C | ASTM D1329 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
