A hard,black,UV resistance thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material combines good physical properties,chemical resisitance and elasticity, designed for extrusion and injection applications.This grade of TPV can be processed on conventional thermoplastics equipment for extrusion,injection molding.It is polyolefin based and completely recyclable.
| Original Document | Technical Datasheet(Chinese&English) | |||
| Features | UV StabiltiyChemical ResistanceThermoplastic Elastomer | |||
| Appearance | Pellets/GranulesBlack | |||
| Processing | InjectionExtrusion | |||
| Compliance | RoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | parallel flow direction, 23°C |
at 100% strain | *** Mpa | ASTM D 412 | parallel flow direction, 23°C |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | parallel flow direction, 23°C |
Tear Strength | *** kN/m | ASTM D 624 | vertical flow direction, 23°C, Die C |
Compression Set | *** % | ASTM D 395 | 23°C,72hr |
Compression Set | *** % | ASTM D 395 | 70°C,22hr |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 10 sec, 23°C |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Burning Rate | *** mm/min | GB/T 8410 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Dielectric Constant(Permittivity) | |||
- | *** - | ASTM D150 | 23°C |
| Aging | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Hardness(Heat Aging) | *** - | ASTM D573 | change, 125°C,168hr |
Tensile Strength(Heat Aging) | *** % | ASTM D573 | change, 125°C,168hr |
Elonggation(Heat Aging) | *** % | ASTM D573 | change, 125°C,168hr |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Weather Stability | |||
Grey Scale | *** - | SAEJ 2527 | 0.55w/㎡, 2100hr, Xenon |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
