This grade combines a very high impact strength, even at low temperatures, with a high stiffness and moderate flow properties.
It is typically used by our customers for injection moulding of technical components and containers exposed to heavy loads and needing a high toughness.
It is typically used by our customers for extrusion applications like thin sheet, corrugated board and profiles.
Health, Safety and Food Contact regulations: Safety Data Sheets (SDS) and Product Safety declarations are available on our Internet site http://www.SABIC.com
The product mentioned herein is in particular not tested and therefore not validated for use in pharmaceutical / medical applications.
This grade material is UL registered under File E111275 (www.ul.com).
IMDS ID: 80775790
| Original Document | Technical Datasheet(English) | |||
| Features | High Stiffness/RigidityHigh ImpactHigh Impact at Low TemperaturCopolymer | |||
| Processing | InjectionExtrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2 | 1 mm/min |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2 | |
Tensile Elongation | |||
Yield | *** % | ISO 527-2 | 50 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
-20℃ (-4℉) | *** kJ/m² | ISO 179/1eA | |
0℃ (32℉) | *** kJ/m² | ISO 179/1eA | |
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | |
Charpy Unnotched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eU | |
Izod Notched Impact Strengh | |||
-20℃ (-4℉) | *** kJ/m² | ISO 180/1A | |
23℃ (73℉) | *** kJ/m² | ISO 180/1A | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ISO 75 | 80*10*4mm |
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75 | 80*10*4mm |
Vicat Softening Temperature(VST) | *** °C | ISO 306/B | 120°C/h, at 50 N (VST/B) |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A | 120°C/h, at 10 N (VST/A) |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
