SABIC PP 511MK46 is specially developed for producing injection molded articles. This grade contains nucleating & antistatic agents. It has mediumhigh flow properties in combination with excellent impact / stiffness balance and excellent organoleptic properties.
SABIC PP 511MK46 encompasses the following features: excellent top load strength & down gauging potential; excellent impact resistance; excellent isotropic shrinkage performance (dimensional stability); high crystallization temperature and excellent flow behavior (lower cycle time); clean product in combination of low / no odor & taste.
TYPICAL APPLICATIONS
SABIC® PP 511MK46 can be used for appliances, housewares, pails & containers and thin wall containers.
| Original Document | Technical Datasheet(English) | |||
| Features | Good StiffnessGood Impact ResistanceDimensional StabilityFast Cycle TimeLow EmissionLow OdorHigh FlowCopolymerIsotropy | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | 23°C |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ASTM D 1238 | |
Mold Shrinkage | |||
- | ***~*** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 A | 1% Secant |
Flexural Modulus | *** Mpa | ASTM D790 B | 1% Secant |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
-20℃ (-4℉) | *** J/m | ASTM D256 | |
23℃ (73℉) | *** J/m | ASTM D256 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell R | *** R | ASTM D785 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Processing Temperature | ***~*** °C | - | |
Mould temperature | ***~*** °C | - |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
