Halogen-free FR-PC/ABS Alloy
FEATURES:
- Halogen-free FR V-0
- Good mechanical properties
- High heat resistance
- Good low-temperature properties
APPLICATIONS:
- Injection molding
- E&E Product
| Original Document | Technical Datasheet(Chinese&English) | |||
| Features | High Impact at Low TemperaturHeat ResistanceFlame RetardantHalogen Free | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | 23℃ |
Melt Mass Flow Rate(MFR) | |||
260°C/2.16 kg | *** g/10min | ASTM D1238 | |
Mold Shrinkage | |||
- | ***~*** % | ASTM D955 | 23℃ |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 638 | 50mm/min |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 50mm/min |
Flexural Modulus | *** Mpa | ASTM D790 | 2mm/min |
Flexural Strength | |||
- | *** Mpa | ASTM D790 | 2mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
-10℃ (14℉) | *** J/m | ASTM D256 | 3.2mm |
23℃ (73℉) | *** J/m | ASTM D256 | 3.2mm |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | 6.4mm |
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ASTM D648 | 6.4mm |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-0 | *** mm | UL94 | |
V-0 | *** mm | UL94 | |
5VB | *** mm | UL94 | |
5VA | *** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Surface Resistivity | *** Ohm | ASTM D257 | |
Dielectric Strength | *** kV/mm | ASTM D149 | 1.6mm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
