High-temperature polyamide lubricant modified, black
Main features:
Low influence from moisture and temperature on dimensional stability and electrical properties, compared with PA66
| Original Document | Technical Datasheet(English) Technical Datasheet(Chinese) | |||
| Features | Heat ResistanceLubricatedDimensional Stability | |||
| Appearance | Pellets/GranulesBlack | |||
| Processing | Fused Filament Fabrication (FFF)3D Printing | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Mold Shrinkage | |||
- | ***~*** % | DIN 16742 | |
Water Absorption | *** % | ISO 62 | 23°C / 24h |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527 | dry, @1 mm/min |
Tensile Strength | |||
- | *** Mpa | ISO 527 | dry, @50 mm/min |
Tensile Elongation | |||
Break | *** % | ISO 527 | dry, @50 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Unnotched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eU | dry, 80x10x4mm |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75/A | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/K | ISO 11359 | 10x8x4 mm |
Thermal Conductivity | *** W/(m K) | ISO 22007 | in plane, hot disk |
Continuous Use Temperature | |||
20000 hr | *** °C | IEC 60216 | |
Temperature at Short Circle Operation | *** °C | IEC 60216 | during lifetime max. 200h |
Processing Temperature | ***~*** °C | - | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Surface Resistivity | *** Ohm | IEC 60093 | ROB |
Insulation Resistance | *** Ohm | IEC 60167 | R25 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
